[timmy]

ok im going to have to figure what resistance to use in the place of the 1250 ohm im sure they will both work but the 1100ohm will get a better result because i add a 5.6k resistor to the 1250 that went up to 1398 in paralle and it brings the resistance down of the 1398 to 1122 ohms and the voltage is 277v for the +270 and the + 140v that was 125v comes up to 135v so i will try the 1250 when i get it and if the voltages come up near to what they should be then ill leave the 1250 in if not ill get a 1100 ohm that states should be in this chassis. i only did this to see if the voltages would come up to where they should be with the proper resistance and it did. originally i had 258v on the +270 source and 125v on the +140v from the audio tube so the difference showed right away with the resistance change in that power resistor.