Quote:
Originally Posted by Dreamsbeard
Just a quick followup on this set ; I never had to do the convergence on it. After I "clean and balanced" it, all I did was to redo grayscale, and all the gun went back into almost perfect convergence...
I suppose that the clean and balance procedure ironicly "debalanced" the 3 guns and that might have resulted in misconvergence (great knowers here might want to correct me on that one of course  )
Now another question : the image on the tv is pulling ever so slightly on the right, thus cutting a bit of the picture. I went around to find an horizontal centering pot, but found none. Is it possible that my TV lacks the needed ajustment to do so?
Thanks! |
First, all sets are built to overscan just a little. Also these days you
gotta watch what you are feeding them.
If you got one put a cross hatch pattern up & be sure the lines are straight.
If not you have a pincushion (pin) problem.
Look for any control or jumper marked horz size, width, or lin.
If it has a horz hold move that a little.
Power supply can do it but usually causes random shut-down & other
symptoms.
If you can check the current draw. Should be about .75 amps with
a normal picture.
If there is a true problem its probably a 'lytic going bad.
73 Zeno