|
I think I left the IF tubes in when I did it, but it's been so long now I can't remember. You put the signal right in to pin 2 or the 6CL6 and chassis ground, right? If it's not getting a picture, you may have a bad AGC pot on your hands. Mine was completely trashed when I first got the set, wouldn't display much of anything. Check to make sure it's responding, then move on to scoping the signal you're injecting at the CRT cathodes. If it's not coming through, there's still some issue somewhere. My set definitely works when injecting composite.
__________________
Evolution...
|