|
Ah ok. That makes sense. I think something may have been up with osc now that I think about it. May have been on its way out. This osc has two adjustment lugs on it. One is the osc, other is listed as the horiz stability, I think. then to either side of the 6CD6 there are two trimmers. One is Horiz Drive, other is Horiz lock.
When I first got the set up and going, the horiz control on front would produce a nasty squeal when turned to one side and the pic would get majorly scrambled (sometime even a dual image), even shrinking horizontally and darken. So I centered the front control and ever so slightly tweaked the osc and stability lugs (counting half turns). Well only after a half turn or so of the stability control the pic locked in and looked pretty good. So I did not continue to mess. However, when reading the proper Horiz adjustments in the set's literature, I noticed that both lugs were way farther out than they should be. Literature gives measurements on how far out stability lug should be when doing proper adjustments. Maybe with the recap and replacing all the out of spec resistors, it finally failed? Definitely a possibility I guess. Horizontal was never quite right on this set. So I am not totally surprised this happened.
__________________
-Al
|