|
ok, looks good thanks for looking into this it will sure be a big help. as for the vert hold pot IIRC the pot was at the minimum resistance when it did seem to me that there was not enough range on that pot but i did change the 2- 6.8 resistors at the 6sl7 and will check them again and the resistors on the hold pot and the vert size pot both were good. and every resistor i checked were very little out of tolorance certainly not enough to cause this. there is a 20 mmf cap c74 at the horizontal oscillator trans that went bad and the oscillator would not run and nearly burned up the horiz size pot so i put a good pot in and tacked in a used .02 ceramic disc that measured 17 and not 20 so i have a 20mmf mica and a .02 cap coming but i dont know if this cap is supposed to be a mica or ceramic . the motorola schematic says that cap 20mmf is molded whatever that means i dont know as i want to put the right one in since i am alittle short on the horiz width and the width pot is maxed but still short of filling the whole screen with no extra range to spare. the caps you mention i have coming except the .1 cap i changed already. as for the tubular caps they are the right values and in the right place. im just concerned as to what cap is the right cap to use in place of the 20mmf c74 mica of ceramic.
|