[tvcollector]

Pin 1 to ground is around 195vdc... Trying to figure out the yoke resistance.. Looking on the sams, and I still can't figure that one out..

Still not sure about the horz output tube.. Shows the lead going to the flyback section where it says to "do not measure", but I don't see any wire going to the fly section from the HV output tube..

I can't have everything hooked up when doing voltage checks, I leave everything in the set, and remove the chassis/tuner/controls/ and set up all that in a different room on a table to work on.. As there is no room.. Yoke stays on pic tube in the set..

I'm following the sams and it says there is a 1240v boost point on the convergence board which is tied into the other higher voltages I listed that are low.. Now I'm measuring without the convergence board hooked up.. Is that why?

Update: I tested voltages with everything hooked up, and I checked pin 7 for voltages and it's even lower.. I noticed the shunt tube filament came up..