|
Good points, gentlemen. Since the set was sent out as "working" I would hope all the components functioned at least well enough to produce sound when it was shipped a few weeks ago. As to wiggling the output tube, would have to figure out which one it is...I did carefully remove and replace all the tubes (using gloves so as not to create hot spots). Also, the power cord is attached to the back panel so I can't wiggle any tubes under power.
Would also have to locate the band switch wafers. Would I have to remove the chassis from the case to do so?
I am sure this is a low-value radio so wouldn't want to put a ton into it to fix it. Any suggestions on a reasonably-priced repair professional? I am in New York.
Anyone interested in it for parts?
|