|
Sencore cr70 Issue help
Hello everyone!
I recently picked up a sencore cr70 off ebay for $80 with all the adapters included, but I sense a problem with some of the functions. First off the emissions never exceed over more than a quarter on the bad side of the dial (I have tried using multiple tubes but I always get the same results) Manual restore and auto restore have no effect although I have checked the voltages from the functions with a voltmeter and the voltage is correct. Cutoff is bad too on all tubes I've checked. The remove G1 shorts is probably the only working function. The fil set works fine, I have checked my pin locations with the ua and all are correct, I do get filament glow, and I got ok hk and g1 shorts readings. I have done a visual inspection and I cant see any visually bad caps. Can anyone help me out here?
Thanks!
|