|
My lack of TV sound seems to be due to my sound IF tube because the getter flash has turned white. I have a new one ordered.
My picture is a tad wide. How do people typically go about correcting width problems? Looking for out of spec caps/resistors in the horizontal output circuit? Tweaking certain cap/resistor values slightly in that circuit (i.e. not going with factory values)? Or is the common thinking basically just "you get what you get" unless the width is WAY off? I'm used to adjusting width coils and/or tweaking width cap values on arcade monitors and I like to get them dialed in "perfectly" so perhaps my expectations are too high for a 50's TV?
|