|
Thanks for all the good advise, as always!
Well, I did try to adjust both the horizontal drive, and frequency, neither made a difference.
There are not many resistors left to replace in the entire set, and I only have about 6 small ceramic caps I could replace in the Horizontal circuit, if by chance one of them may be bad...
I will also check the coil to make sure it's soldered well to the board, and no cracks anywhere... and check the hold pot with my meter...
I was also thinking, would the horizontal sweep typically have to be re adjusted after replacing caps and resistors and diodes?
If so, Sams gives me the procedure... Just not sure how to:
"clip a lead across the stabalizer coil"
|