Quote:
Originally Posted by DaveWM
no.
|
I guess that thin wire is just excess? It looks as though that wire I showed a photo of, starts where it looks "broken", goes up, is glued to the PC board, then comes back down, and into a small hole of the PC board...
Quote:
|
Did you check the horz pot connections and did you confirm continuity of the pot end terminals?
|
Yes...
I tried both the Hold, and local distance... both had continuity.
The Hor.Hold Pot read 7.05 on the end terminals, and when I tested on the center wiper and turned the pot, it went from 0... up to 7.05 with my multimeter set at 20K resistance.
I think it's a 10K pot, but unfortunately, even though my sams schematic shows basically the same chassis layout, there are different values, and some caps and resistors are in different places than my set...
I wish I could find the exact schematic for my set, but after looking for a long time, this was the closest sams had...