Welp, a big thanks to you guy's!!!
I checked over a bunch of resistors in that circut. Most have drifted up some. I'll probably replace a good number, before i'm all done as they are right above the 20% tolerance.
Also printed out the schematic and had that in front of me. I'm surprised at how many caps were (previously) replaced with values that didn't match.(the schematic)
I don't know if I should switch my replacement's now that are in there, or just leave it as is(I didn't use the schematic to recap, just went by what was inside)
Anyway's I found that adjustment coil, and decided to see what I could do. After several turns clockwise, I could see the images blocked up on top of each other. Kept going and it locked into one full image!
I then dialed it in with the horiz. hold control and centered it in the control.
Wow, I got a pretty damn good looking picture
....but IT's UPSIDE DOWN!!!lol
Yoke is positioned correctly...do I have the vertical connections on the yoke miswired??
I also still need to center the picture as well. I notice that it's got a little wave as well and slight geometry issues... And an issue with the best sound and best image not being together with the fine tuning control. Has some buzz and gets quiet when adjusted to best image, and a cruddy looking image when it's adjusted to lowdest sound.
Well I've still got more ahead to do, but that's where i'm at for now.
Now some pictures!!