Quote:
Originally Posted by jr_tech
Apparently there is no external 9-10 khz switch on the radio, but did you check the circuit board for a strap (or possibly a low ohm resistor) that could be clipped or moved to the 10 khz position?
jr
|
I looked at the board, next to the PLL chip, but didn't see anything marked as such.
I can't see the chip number. It looks like it was marked over with ink or paint. I wanted to see the pin-out and figure it out.
It actually looks like an almost decent performer. It has a rather good sounding speaker and the output chip, has a heat sink on it. It seems to be a better looking piece of junk.
Ordinarily, you should be able to look up the chip number on the I-net for the function and pin-out.