|
Looking good! What's the HOT cathode current running?
Always replace the cap attached to the cathode of the 'GF7 - that cap, more than any will cause problems with the vertical. Also go over the ground eyelets on the boards. Vertical / horizontal sync problems are generally caused by resistors way out of tolerance. I've restored three CTC16 sets, and outside of electros, the cathode cap, the sync resistors, and a thermistor or two, I've never replaced a single film cap.
Also clean the pins on the IF tubes - video will suffer If problems there.
Like I said, looking real good!!
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"
When fuses go to work, they quit!
|