|
Thanks for the compliment "round screen". Well I got another NOS Horizontal output and a NOS damper tube, and the set hardly pulls in at all unless I crank up the brightness way too high. Cathode current of the 6CB5 I think is a little high, 223 ma or so, and I tried adjusting the horizontal efficiency (linearity) coil and that is the minimum current I can get it adjusted to. Picture even looks a little better with the tubes in there. High voltage is running around 22 to 23KV, but it will not adjust up to 25KV as per the Sams. I'm not sure though if my probe though is completely accurate. Actually I haven't even touched the dynamic convergence yet, and it looks fairly close. I just did the center convergence and purity, and purity is still off a bit, but will make final and closer adjustments when I get the cabinet touched up or refinished, and the chassis back into the set.
|