Quote:
Originally Posted by jr_tech
I think that it should be fairly easy to fabricate a suitable tool by grinding flats on the outside of a smaller socket or Xcelite driver. Likely a 1/2" size would work fine. I made this example in about 5 minutes... wrong size, but it shows what could be done.
jr
|
I did the same thing. I ground the down the flats on a 5/16-18 nut and used my 1/2 socket, no luck. Naturally, the ID of the nut, had to be drilled out to accept the control bushing.
I didn't think, Magnavox used that arrangement that early. The HI-FI in question appears to be a 1957 model.