|
Hi Swizzyman,
Do you have a scope to check the waveform at pin 1 (grid) of the 6au6 sync sep?
It should look similar to the waveform at the output of L16 ( where the syn signal is removed from the 6AC7 video amp output). Make sure inductor L16 is not open. The output signal of your 6AU6 syn seperator pin 6 should only
be a pulse without any video image information. If you don't have the enough of a pulse signal going into the sync phase splitter then you will never get the
horizontal or vertical oscillator to lock in. The vertical pulse is the summation of all horizontal pulse after passing through the intergator network R59 thru R61 along with C41 thru C43.
If you don't have a scope, check L16 just in case. It should be a low resistance.
Sam's says to measure the 6AU6 AGC voltages from pin 7 (cathode) to other pins.
pin1 (-6.8vdc)
pin5 (-140vdc)
pin6 (+115vdc)
Ed
|