|
the next thing to do is replace the vertical hold and linearity controls, the linearity is shot, it's dead past a certain point and I can't get the vertical perfect.
It's a double pot in a single case, the Sams lists two different part numbers for replacing it. I suppose I could just use a couple pots of the correct value.
Question, Sams says the linearity is 6000 ohms with a 1000 ohm stop, the Height is eight meg with a one meg stop.
Where would you even find an 8 meg pot?
I think those holes punched in the back of the controls are probably the stops?
|