|
Ok so I'm going with the voltages are good. Now if the mod is not done for retrace lines, 220k resistor with the cap , then you have lines left to right on the top of the screen going half way down and fading once done they are gone with hi brightness. I have 2 other sets I done this mod on and both are good however this one I got done has the 220k resistor done already looks factory and checked the resistor and its 220.7k. What I don't get is the lines you get if this mod is not done, on the top I have the same lines on the bottom left to right up half way up the screen the complete opposite . I do notice at hi brightness the lines are there but certain scene changes they almost disappear. I can lower the brightness and the lines are gone but the brightness suffers and I'm left with a somewhat dark picture when the tube is capable of being bright. So this has me baffled why the lines are on the bottom as if the retrace mod was not done and the lines just went to the bottom rather then the top where they would normally be. Any ideas would be great...
|