|
I've gone as far as I can. I think the horiz is running off frequency. I can see what looks like a blurred overlapping image on the screen. I checked the horiz hold control, and it's fine. The horiz lin control measures good. I even replaced the 56pf cap on the yoke for the horiz. I posted most of the schematic, but the hoirz and HV section can be found on PG 2 of this thread at post 10 that starts as "I've completely lost the raster." It wouldn't let me repost the same pic again.
If someone recognizes the problem or has any ideas of that's wrong, please advise me as I'm about to give up on it.
Thanks
Doug
Also, this set has 3 trimmer caps. Horiz lock, horiz drive, and horiz freq. Lock and drive have to be screwed in almost completely or I lose what raster I have. Freq seems to make no difference.
|