Quote:
Originally Posted by zeno
IIRC the P6 had an odd ball pass regulator. Both a transistor
& an STR. A small cap would open & a resistor would burn.
I dont have a manual & my memory is not there.
So attack the regulator & look for the resistor. IIRC it was
near a heat sink.
BTW careful not to run it too long or the HOT may short again.
73 Zeno  |
Use this X6 service manual, it's close enough.
R432 is fine. Q400 isn't shorted. Measuring between IC410 pins 2 (BASE) and 4 (OUT) shows 2.75K ohms in-circuit. Is this normal?
__________________
I'm in need of service manuals for the following:
Magnavox 19C315-CC, Emerson ECT-1300A (TM0110E), Sears 401.50300900
|