I got some more done on the chassis recapping.
I changed out the cap "C46" and resistor "R62"on the "Contrast" and "Horizontal Hold" control.
I then began recapping and rewiring the fuse and selenium rectifier. I'm using a terminal strip for each. I'm using pigtail fuses. For the rectifier, I'll wire the original selenium in then get some voltage measurements, then change it out for a 1N4007 diode. Then I'll adjust the existing 22 ohm resistor "R77" to match the correct voltage needed.
I'm needing my .2uf 630v caps from Just Radios to really get into recapping. The caps are "layered" and I'm not going to do much till I have all the caps on hand. There is some that I can do though. Just a limited amount.
I also changed out another cap "C54" and one of the heat stressed resistors "R77".
