[madlabs]

Bob, thanks! The price is right too. Added 4 of them to the ever growing Mouser order. Also been watching your Holiday resto videos, very helpful and informative.

Dug up some power resistors out of the stash that will work for the multi-tap sand resistor. I'm kinda surprised that the value of that had drifted so high, I've never seen a power resistor drift so much. Are those wirewound?

At work for 48 hours but should have some time to replace the power resistor on Thursday. Didn't get the order in so no new parts bonanza arriving this week. The 21FAP4 will get here this week though. Fingers crossed it arrives intact! And that it will work on a Predicta. We shall see. I was thinking of cutting the CRT wires I need to be able to swap up near the socket and putting bullet connectors on them. That way I can test the 21FAP4 works but continue to use the one the set came with if it has any life.

Thanks all! Really appreciate all the help and advice.

Jonathan

EDIT: I didn't put a link for the bullet connectors, but there is an epay link to actual bullet connectors?