I decided to power it up again to check my progress so far. The good news is that it powered up nicely and my B+ is 244 volts. Sams lists 238 volts. I also have a raster and each control seems to do something. Like Brightness does control the brightness and so on. I only have a low level buzz coming through the speaker which can be varied with the volume control. Also no video.
I tried wiggling each tube but that didn't help. On a few like the sound IF amp it clicked pretty loud in the speaker. Seeing I haven't gotten to the IF stages yet, I'm not surprised.
What's left to do is the 3 IF stages, Video Detector, a little in the Video Amp, Sound IF amp, Ratio Detector, Sync Amp-Sync Separator, and the Sync Clipper.
Once these are done then I'll have to get into the troubleshooting phase. So far so good.
