Bob and everybody,
I did it! My curve doesn't quite look like the one in Sams, but close. What I did was look at the curve from my AMC 116T that I just did and it didn't have a large flat in the curve. I never touched the IF's on that TV. Sorta for a reference.
I then hooked up the Admiral and using the generator and VTVM, I again peaked the 4 coils.
Then on to the 369 and O'scope. From here I did just what Bob said to do. Adjust each coil and finally got this curve. I also spent some time doing some little tweaking till I got the pips where they were supposed to be. Also the curve bandwidth and shape. Bob was right, I had to go back and forth among all 4 coils and at times it was a bit frustrating. But I knew I would get it at one time the 24.3 pip was now lower when before it was higher. This gave me the indication that what Bob said about moving the peaks to get the pips where they needed to be. I suppose I could have tweaked a little more here or there, though I'm not too sure. I concentrated on getting the pips on the curve in the right position and frequencies.
Here are my results. The pips start at the left of the curve and work their way to the right and to a lower frequency. I flipped over my curve printout (from Riders) and traced the curve and markings just to keep from going nuts.
I did hook up my DVD player and sure enough I have good video! I tweaked the audio a bit and the rest will wait till tomorrow.
A big thanks to Bob and the others who helped me through this. I learned a lot and next time it will be a lot easier!
