View Single Post
  #10  
Old 10-27-2016, 08:05 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by centralradio View Post
I remember back in 1980 when I hooked up a Sears 19 inch up to the cable and a huge spark came from the connector.More likely it did not have a polarized plug on it or it was mis-wired .I turned the plug and it was ok.I still have the set somewhere.I'll take it out and look and see if I rewired it with a new polarized plug.
Or the outlet was mis-wired. Talk to home inspectors - the DIY crowd is very ignorant to AC polarity. I've seen mis-wired sockets in homes, businesses, barracks, and even at a radio transmitter site - Every 7 hours or so, a breaker would trip, and a tech would be dispatched to reset the breaker. The tech got overtime, so troubleshooting wasn't to his benefit. Two installers (one is a good friend) got a fright when their equipment smoked, and they did the troubleshooting. Found three circuits with some sort of polarity or phasing difference. The techs' overtime dried up, and after some explaining, so did his job.

In the early days of hot chassis and grounded test equipment, I saw scopes get eaten, a CTC101 with a vertical problem become a non-economical repair, and two outlet covers get arc'ed to - the chassis was slid around, contacting the grounded cover.
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote
Audiokarma