[SwizzyMan]

Finished recapping (finally). I have to say some spots were very hard to work at, the convergence module being the most difficult. Overall recapping this set was relatively stressful to the fact I was working around fragile coils and try not to drip any solder on anything. I also made sure to check all my connections with my Ohmeter. I decided to give it the shrink wrap treatment since this set is a hard to find set and neatness is a must. I have yet to fire it up and quite frankly im a bit scared to do so since Im worried I might have accidentally broken a coil or a coil in the convergence module, while I don't recall messing up too bad anywhere (with the exception of 2 or 3 solder dropping mishaps) I'm still scared out of my mind about powering it up since this set is relatively rare. I hope the power up goes well!