[madlabs]

Digging through my mica caps I don't have a 390pF, but I do have two 150pF and two 50pF that measure out at 396pF. I would have to wait a week to get anything ordered and I am dying to see if the new A11/12 audio adjustment works. Is it electronically foolish to use the four cap combo? I don't care about style points and I'm going to order a few anyway and I'm sure I'll have the PCB off again or can take it off.

The Sams for my set shows and has a 270 ohm, 3 watt resistor. It does go to the vert. lin. pot. As it happens, that is one of the few resistors that I left the old one in place as it tested good. I think I'll peel that one out and replace it.

The vert. lin. pot measure 900 ohms, works smoothly. I will swap the tubes again. I did before but so much has been done and I'm not sure when I tried it in the process.

I feel like I'm getting close. Thanks for all the help!

EDIT: I forgot to ask, if ordering a new mica cap, is it worth it to get a N0 cap?