Well, I started messing with the kit. I went up to the copy place and made copies and pdf's of the 6 instruction sheets to assemble the TV, the instruction booklet that goes into alignment and troubleshooting. The booklet also has the schematic which again I made a large copy and then pdf it. Also a large sheet that covers the IF strip instructions was copied and pdf. The pdf's are huge like from over 1mb to just under 5mb. I'll share those with everybody if I knew how. I also have copies and pdf of the Supplementary sheets. Basically if it came with the kit, it was copied and pdf!
Over the years the chassis cad plating has turned a yellowish green both on the top and underneath the chassis and yoke support. I have several pictures that show how bad it was.
Here is a picture of the IF Strip from the bottom:
I did inventory and took a lot of pictures of each bag. That will be a separate post.
Here is another view of the bottom of the chassis:
Here is proof that it was aligned:
