I followed the instruction sheet pretty much step-by-step. When I ran a wire or installed a component, I highlighted it on a copy of the instruction sheet. I didn't have the .0047uf film cap yet so I just skipped that step. Also I removed the twin lead from the tuner and chassis because it was in the way and getting beat up from handling the chassis. I removed it a while ago.
I do have question and that is there are 2 peaking coils that I installed. A black dot and a red dot. When I installed them to the terminal strips and tube socket, I installed them a little higher up than I normally would think. I remember always seeing these coils mounted higher than the other components. So I did the same. They are about 1/2" higher than the top on the terminal on the terminal strip. Any comments?
C52, C57, and C62 were all safety caps, rather than the paper caps called out in the instruction sheet.
Here are some general photos of where I am.
