This morning I decided to make a couple of mods to the build.
The first one was to T5 the Synchrogiude Transformer. When mounted to the chassis, the terminals were rotated 90 degrees and then they didn't match the instruction sheet.
Now I had already wired it in but decided that I could turn the guts 90 degrees to match the instruction sheet. After un-soldering the components and removing the transformer, I pried open the case by rolling the edges back even with the sides of the case. I then removed the coil and its base.
I then turned the top metal "clip" 90 degrees to match the instruction sheet. I then inserted the coils back in the case and rolled the bottom edge back over using a small dowel. Now the transformer matches the instruction sheet. I then reinstalled the components.