The other mod was to the two big caps that have a 90 degree bend on their right hand lead. I really didn't like that too much. So I added another terminal strip to terminate those leads. I cut off the end of a terminal strip and mounted it using an existing terminal strip hardware.
Then I re-did those capacitors.
Much better now!
The last redo was to the 150K resistor next to the up and down terminal strip on the left hand side (TB12). I had to add a longer lead length because it went to another terminal strip. Look closely.
I checked the rest of the instruction sheets and a couple of terminals weren't going to be used on TB13. So I ran the resistor from TB12 terminal strip to the new location TB13 and added a jumper between TB13 and TB14.