OK, first problem.
I can't get the CRT into good focus. The yoke is pushed all the way forward up on the CRT. This is an aluminized tube so no ION Trap.
HV is shown at 11KV on my unreliable HV probe.
I did notice this statement from the GE datasheet for a 21FP4/A/C, the CRT I'm using is a 21FP4C. It states having a minimum resistance on Pin 6 (Focus) and Pin 10 (Grid 2 B++). See attached photo. This TV does not have a minimum resistance on pin 6. it goes directly to B-. Should I have at least a 100K resistor in there?
