[bandersen]

I finally had the time and patience to remove all the wood screws holding the front on. I sure didn't expect the whole from to come off like that!



The speaker is in very good condition and I found the pilot lamp and holder to be intact down at the bottom.


Unfortunately, the donor plastic dial scale is cracked.


I removed the speaker form the donor chassis and it slid right into the cabinet


Then I installed a genuine RCA Victor 10BP4.



Finally, here it is all back together with knobs. If I had access to an outlet, I'd have fired it up. That will have to wait until and I move and get a workshop setup again.