Quote:
Originally Posted by Crist Rigott
I cleaned up and painted the bleeder resistor housing and re-installed it and wired it back up. Note that I use a small piece if 1/8 clear heat shrink on the ends of the cloth covered wire to "tidy" up the end. It keeps the insulation from fraying all over the place and messy looking.
 |
Hope you used high temp paint...If it is anything like a 630 chassis those power resistors get hot enough to solder with! The heat shrink is probably going to degrade after ~100 hours run time too.
Some places it is better to be practical than a perfectionist.