|
Yes I mean the Horiz oscillator adjustment procedure. I have looked in the manual and tried to follow. The process doesn't seem too bad by any means, there is just the fact this is my first time trying this and so far there have been many snags. Tube sets have always been so cool and satisfying when you save one from the dump, but fixing them has been another story.
Good info on the adjustment. I am trying real hard to get this sorted, but has there ever been a case where the Horiz oscillator can not be gotten close enough to be adjusted with a scope? That is the worry with this set so far. I can adjust and change the pitch of the HV but it is never even close. In the manual for this set there are many troubleshooting processes but none that have the Horiz working while also having no raster. At this point it looks like it may be best to try harder to find someone local who can give some hands on guidance with this.
Yes this set has the drive, width, etc. Adjusting those did not change anything, but they probably just made it worse. Oh well it is a learning experience.
Sounds like it's time to search for more junk sets. So far the couple tube sets I have are the only ones that have shown up in years of searching the area. Before doing anything it looks like this set has a lot of slack and extra wire so I will scoot the chassis out with everything hooked up and see how many test points are accessible. Something to do tomorrow or in the next couple days.
|