|
Your 22JU6 voltages are fine except pin 8, you got 37V but it should be 25V.
You should measure on the other side of R77, the voltage should be near 145V. Also check the value of R77, should measure 47K.
Your 8FQ7 are nearly all wrong! Did you measure the wrong tube?
Yes, check out the yoke. Perhaps there is a short or maybe is arced because the voltage got too high somewhere.
When you measure the filament pins you need to use the AC volt ranges.
Last edited by Notimetolooz; 11-01-2018 at 08:00 PM.
Reason: Typos
|