|
OK so I got the tuning dial string restrung properly finally but now I have a new problem. When I first got this thing and powered it up when I got it home, it worked fine, didn't even hum, but now that I took it apart to repair the dial string and repair the dial lamp that was cut out of the circuit in the tuning dial pointer I went to hook it back up to test it and now the unit wont power on (the tubes wont warm up and the dial lamps won't glow).
Any ideas as to what might of happened with the unit, and what I might look for to try and get it to run again?
Also I did replace some tubes that measured bad including the rectifier tube (they weren't completely bad but they measured right around the question mark or a little lower on the tube tester).
any information would be helpful.
|