Quote:
Originally Posted by Electronic M
Start with all the electrolytic caps in the vertical (IIRC one is mounted on the convergence board). Change the orange/maroon drops in the vertical stage too if the lytics are not it. Many say drops don't fail, but in sweep stages and some in the color stages close to tubes do go bad in these sets (I've tested caps for leakage to full working voltage on my Heathkit C3 to learn this).
|
This did the trick Tom! I went ahead and replaced all the orange/maroon drops on the sweep board and vertical is working perfectly
sized up perfect and easily, locks in perfect with a wide range.
The horizontal has a lot left to be desired. it can be centered, but with controls at almost their max.
I am contemplating going though and getting the rest of the orange/maroon drops on all the other boards and re stuffing them 3 electro cans.. what's your option Tom on that doing that? My largest fear is putting the set out of alignment by changing out all them caps.