|
Here is where things are now...
The set it pretty much in the shape as when I first got it. ( after undoing the color PCB being out ).
No color, sometimes barber-pole effect seen, unknown if it's IF related, (evidence of work done in IF PCB )
ALL resistors replaced on color PCB , except for higher power ones, some disc caps new, not sure of any else.
Apparent burst amp / color kill problem , which I am assuming is shutting off chroma bandpass, ( if I understand the circuit ) .
No video signal seen out of c22, feeding l24 ( bandpass coil ) . Saw suggestion in other thread to short point E, to force on, not tried yet.
Cathode voltage of burst amp too high, (V22) not sure why yet, all resistors new, tube “new” (another ordered) voltage starts at 20v when first turned on, and jumps to about 130v when horz kicks in.
plate/g2 voltage OK, was unable to measure g1 voltage with DVM, due to strong waveform on it ( gonna have to get my analog meter cleaned and working ) .
New, ( relatively ) v22 6JC6 coming fri, & a set of HV disc caps come mid-week, will replace c95,98,99,100 and re-test this weekend.
I hope this does something... but it may not, there may be problems elsewhere, as mentioned, I still don't fully understand this circuit yet, it seems to be a balanced feedback setup, but that is a guess.
|