|
OK, update...
After spending nearly 2 hours checking every resistor that was replaced on the color PCB, I found one more that was wrong, R170 has a 10k in it where it should be 27k ( so says SAMS ).
Other than a lot of crappy lead shaping and sloppy solder work, the other resistors are OK. ( I have a very critical eye for lead shaping and solder form, this comes from my many years in the industrial electronics field ) .
There are a few caps that still look old, that I will most likely change this weekend.
However, I really doubt that this will fix the problems, for I'm pretty sure that the putz who did this messed with the IF section and I have no real way to align it.
So once I am done checking the color PCB, I will try again to tap in video at the 1st video amp, this time lift up one end of l9, and try color setup with external video, this MAY cause a problem because composite video is 1v PtP and the wave shown at that point is 3.5, I may have to build a small video amp, or it may not care.
|