Quote:
Originally Posted by jr_tech
Make sure that no sharp points were created by cutting the wires of the new parts.
And also make sure that the insulated board that the hv pots are mounted on is clean and free of carbon tracks.
Can you see where the arc occurs in a darkened room?
jr
|
I had my daughter help me make a video of the arcing. I may post it but I'm not sure it shows up clearly enough. However, I'm convinced now that the arcing is occurring inside the control. As I mentioned in another reply, this control is soldered directly to another pot and I'm going to have think through this a bit. I may need to order some new solder wicking too. Is there any possibility of a repair on something like this?