View Single Post
  #23  
Old 06-26-2019, 08:03 AM
maxhifi's Avatar
maxhifi maxhifi is offline
VideoKarma Member
 
Join Date: Dec 2010
Posts: 1,871
More exciting developments:
Screen voltage can be varied from 500-750V approx, and and the G1 Kine Bias is set to about 10V.

The focus take off point of the multiplier is about 6kV, and high voltage is about 23kV. My high voltage probe often reads low.

Good continuity though focus controls and focus voltage divider resistors.

The chassis can be very easily pulled, and really is just a console chassis. All wires have enough slack it can be operated while the bottom is accessible.Nothing under it appears damaged in any way.

The neck board has power supply voltages screened on to the board, and they measure as they should.

Not having service data, its impossible to know for sure, but after measuring voltages I think my theory that the tube are over biased is wrong, and I should instead be looking to the video amplifier.

Last edited by maxhifi; 06-26-2019 at 08:07 AM.
Reply With Quote