|
OK so this TV's Power Supply Cap Can is a 40/40/40 @ 450 VDC I would of tried to keep the original cap in place for appearances sake but somehow the phenolic wafer that the power supply filter was attached to was snaped off at the chassis so the power supply filter cap is just hanging on the chassis by its wires and what not.
I'm thinking of mounting a small terminal strip under the chassis near where the original power supply filter cap was originally as there is a blank hole located conveniently next to where the old filter caps are that I could bolt the terminal strip to.
I'm assuming that the wires that were attached to the mounting tabs on the original can capacitor were using those as grounding terminals or junction points of some sort and aren't critical as to where they are relocated to?
|