|
I did replace the grid resistor, (390k) plate resistor (47k) & coupling cap (.22) , I did see that it is very closely tied to the CRT bias switch, but I did not change any of those resistors there, cause I did not think it would have that much of effect, I do see that the cathode of the blanking amp is tied to the cathode of the bandpass, 820pf / 390 ohm paralell to gnd, these were replaced by the person who had it before me , the resistor checked OK (5% carbon film) the cap was correct, (checked by # on top)
I guess I should have replaced them too . :/
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
Last edited by Yamamaya42; 09-23-2019 at 12:59 PM.
|