|
Yes. This is what you want to do. Maybe go find a few small low power puck style magnets and attempt to position them on those areas on the back of the CRT to align the corner convergence. it's tough (and dangerous) so be careful. Try to hold the magnet with some insulated pliers and take note not to drop the magnet on the PCB or yoke windings. That would be bad. But if you can find an area that will align the corners, stick it there. Its tricky and if the magnet is too powerful, you will feel the energization of the CRT so use insulated pliers. I've done this before with mixed results.
__________________
Honey, turn on the tv.. I'm cold!
Last edited by freakaftr8; 10-30-2019 at 01:34 PM.
|