Quote:
Originally Posted by Kevin Kuehn
I should have told you to also measure the voltage which goes to pin 2 of the CRT socket referenced to chassis ground, should be 1.3vdc. You can get to that under the chassis on the end R35 that should be connected to another wire going up to pin 2 of the CRT socket. Use the resistor identification on page 17 of your sams to find the actual physical location of the resistors.
|
OK, Pin 2 of the CRT is about 1.6 VDC which is only .3 volts higher than the reading given in the Sam's Voltage Chart, so I would say those 3 voltages are in the ballpark of where they should be.
So now how do I go about adjusting the Ion Trap on this TV?