Quote:
Originally Posted by Kevin Kuehn
Is there any wiggle room in the mounting holes for the transformer bracket that would allow it to shift upward, or possibly you could drill out the holes a little more. Ideally you want to be able to fine tune the position after all the chassis screws are started. The chassis screws should act as clamps and not precision locating points.
|
Well it turns out that I think what the problem is, is my picture tube.
Unfortunately I had this problem before, I had to move the picture tube forward slightly in the chassis in order for me to get the picture to fill out properly but that slight move forward of the picture tube is just enough to make it so that the chassis doesn't fit into the cabinet properly anymore.
Which is why I had to move it back to where it was before which is how I screwed up the picture the first time when I had the picture filled out like it was supposed to be, so then when I did it again this time it was the same issue.
Is it possible that this picture tube (which I suspect is a replacement) is longer than the orginal one was, so because of that it doesn't work right with this particular chassis and perhaps this TV never worked right to begin with after the picture tube was replaced?