|
The Sams shows that 30 at 250 volt cap to be C117. From pin 9 of the flyback there is a diode CR112 with a small cap across it C116 that connects to a 4.7 ohm resistor R125, the resistor is probably raised above the printed board on 2 metal "stakes", then C117 is connected to the resistor and the wire run up to the CRT socket board. It then connects to the junction of R8 and R13 shown at the top of the picture you posted. Looks like it might say "9B" with L1 under it.( Sometimes the board call out numbers may be abbreviated. Example, C117 may just show C7, or CR112 may just be CR12)
|