Quote:
Originally Posted by noah300g
Thanks,
The socket is a little wonky, in that I had to wiggle the tube to get filament conductivity to make the TV work at all (series filament set). I seem to have correct resistance readings from pins when tube is removed, but I'll double check.
|
Still, the only way to get zero voltage drop across the plate resistor is zero current. This could be caused by an open connection in the cathode, or screen grid circuit, or even between the plate pin and the socket, or it could be caused by low or inadequate screen voltage. it could also (less likely) just be a bad tube. You found the issue here, just need to resolve it now.